Jewel Rules
We’ll give you a list of every supply you need, and we’ll take you through each step. Before you know it, you’ll be strutting your stuff in dazzling, dangly style!
Inspired?Share it:
Project Instructions
-
Step 1
Use wire cutters to remove desired beads from strands.
-
Step 2
To form the loop that will attach the beads to the jump rings, feed a headpin through each chunky bead. Holding the bead in your fingers, use the round-nose pliers to curl the tail of the pin into a loop.
-
Step 3
Slide two small beads onto a headpin, and curl the tail of the pin into a loop, again forming it as close to the bead as possible. Remove tail with wire cutters. Repeat as desired.
-
Step 4
Use 6mm jump rings to attach bead dangles to toggle clasp.
-
Step 5
Carefully open one fishhook wire. Place beaded toggle onto loop, and close. Repeat for other earring.
-
Items You Will Need
Quantities shown below are recommended
