Refresh your space.
Wrap your head around this: These beaded bracelets are way simpler to make than you might think! Check out this quick step-by-step to learn how to DIY your own leather beaded wrap bracelet.
Gather supplies. Begin by wrapping leather cording loosely around wrist several times. Add 2-3 inches to length, double it, and cut.
With cording folded in half, tie knot, creating 1/2-inch loop at end. Secure loop to work surface with tape, and cut strand of monofilament cord that’s two arm-lengths long. Tie monofilament cord around leather cord on left side, and secure with drop of super glue.
String one bead onto monofilament cord, and center bead between leather cords.
Feed monofilament cord under and around right-hand leather cord, and then thread it through opposite side of bead. Now go under left-hand leather cord with monofilament cord and back around to top. Pull cord tight, making sure bead is snug between leather cord pieces.
Continue with same technique until all beads are strung, switching bead styles if desired.
To finish, tie monofilament cord tightly around one leather cord piece. Clip off extra, and add drop of super glue to secure. Tie leather cord pieces together, and it’s ready to wear!
Quantities shown below are recommended