Get something to style every room.
Use wire cutters to remove desired beads from strands.
To form the loop that will attach the beads to the jump rings, feed a headpin through each chunky bead. Holding the bead in your fingers, use the round-nose pliers to curl the tail of the pin into a loop.
Slide two small beads onto a headpin, and curl the tail of the pin into a loop, again forming it as close to the bead as possible. Remove tail with wire cutters. Repeat as desired.
Use 6mm jump rings to attach bead dangles to toggle clasp.
Carefully open one fishhook wire. Place beaded toggle onto loop, and close. Repeat for other earring.
Quantities shown below are recommended